Skip to content

Configuring Initial Setup Parameters

Before you use your Tera2 PCoIP Zero Client for the first time, you need to configure initial setup parameters, including setting basic audio, network, and session information.

You can perform this initial setup from the AWI Initial Setup page, shown next.

Alt text
AWI Initial Setup page

The following parameters display on the AWI Initial Setup page:

Audio Parameters

Parameter Description
Enable HD Audio Enables audio support on the client.

Configuring other audio parameters

You can configure other audio parameters from the OSD and AWI Audio pages. To configure audio parameters from these pages, see Configuring Audio.

Network Parameters

Parameter Description
Enable DHCP Enables DHCP (as opposed to using manual IP address configuration)
IP Address Device’s IP address
Subnet Mask Device’s subnet mask
Gateway Device’s gateway IP address
Primary DNS Server Device’s primary DNS IP address
Secondary DNS Server Device’s secondary DNS IP address

You can also configure network settings from the OSD and AWI Network pages

You can configure the initial setup settings, as well as other network settings, from the OSD and AWI Network pages. To configure network settings from these pages, see Configuring Network Settings.

Session Parameters

Parameter Description
Identify Host By Specifies the host identify method
Host IP Address Specifies the host IP address
Host MAC Address Specifies the host MAC address.
You can set the host MAC address to 00-00-00-00-00-00 to ignore this field when a session starts.

To configure initial setup parameters from the AWI:

  1. From the AWI, select Configuration > Initial Setup.
  2. From the AWI Initial Setup page, configure audio, network, and session parameters.
  3. Click Apply to save your configuration.