Skip to content

Configuring the PCoIP Agent

You can configure the PCoIP agent, and optimize PCoIP protocol behavior for local network conditions, by adjusting Windows GPO variables.

The variables are in admx template files, which are imported automatically by the agent installer.

Template files on domain controllers are not automatically installed

Template files are not automatically installed on domain controllers. You must manually import the files into the domain controller's Group Policy Editor.

Modifying PCoIP GPO Variables

All of the PCoIP settings can be configured using this procedure. The configurable settings are described in the following section.

To modify a PCoIP session variable:

  1. Open the Local Group Policy Editor on the agent machine:

    1. Press + r to open the run dialog
    2. type gpedit.msc and press Enter.

  2. In the left pane, navigate to Administrative Templates and then to PCoIP Session Variables.

    The variables you can configure appear in the right pane.

  3. Double-click the PCoIP variable you want to configure to open the variable's configuration window, then:

    1. Select Enabled to enable the PCoIP setting.

    2. Configure any parameters that are available for the setting.

    3. Click OK to close the variable's configuration window.

  4. Repeat step 3 until all variables have been set.

  5. Close the Local Group Policy Editor.

Note: Changes require a new PCoIP connection

Changes take effect on the next PCoIP connection to the desktop.