The Session Statistics page lets you view current statistics when a session is active. If a session is not active, the statistics from the last session will display. You can access this page from the Diagnostics > Session Statistics menu.
AWI Client Session Statistics Page
Note: The above figure shows session statistics for a client with two connected displays. If your deployment uses four displays, information for all four displays will appear in this section.
AWI Client Session Statistics Page Parameters
Parameters | Description |
---|---|
Connection State |
The current (or last) state of the PCoIP session. Values include the following:
|
802.1X Authentication Status |
Indicates whether 802.1x authentication is enabled or disabled on the device. |
PCoIP Packets Statistics |
PCoIP Packets Sent: The total number of PCoIP packets sent in the current/last session. PCoIP Packets Received: The total number of PCoIP packets received in the current/last session. PCoIP Packets Lost: The total number of PCoIP packets lost in the current/last session. |
Bytes |
Bytes Sent: The total number of bytes sent in the current/last session. Bytes Received: The total number of bytes received in the current/last session. |
Round Trip Latency |
The minimum, average, and maximum round-trip PCoIP system and network latency in milliseconds (+/- 1 ms). |
Bandwidth Statistics |
Transmit Bandwidth: The minimum, average, and maximum traffic transmitted by the Tera processor. The active bandwidth limit is the maximum amount of network traffic the Tera processor may currently generate. The value is derived from the configured bandwidth parameters and the current (or last) network congestion levels. Receive Bandwidth: The minimum, average, and maximum traffic received by the Tera processor. |
Pipeline Processing Rate |
How much image data is currently being processed by the image engine (in megapixels per second). |
Endpoint Image Settings In Use |
Displays if the image settings being used are configured within the client or within the host. This is based on how the Use Client Image Settings field is configured on the Image page for the host device. |
Initial Image Quality |
The minimum and maximum quality setting is taken from the Image page for the device. |
Image Quality Preference |
This setting is taken from the Image Quality Preference field on the Image page. The value determines if the image is set to a smoother versus a sharper image. |
Build to Lossless |
Options that may appear in this field include the following: Enabled: The Disable Build to Lossless field on the Image page is unchecked. Disabled: The Disable Build to Lossless field is checked. |
Reset Statistics |
Click this button to reset the statistic information on this page. Note: The Reset Statistics button also resets the statistics reported in the Home page. |
Display |
The port number for the display. |
Maximum Rate |
This column shows the refresh rate of the attached display. If the Maximum Rate field on the Image page is set to 0 (i.e., there is no limit), the maximum rate is taken from the monitor's refresh rate. If the Maximum Rate field on the Image page is set to a value greater than 0, the refresh rate shows as "User Defined." |
Output Process Rate |
The frame rate currently being sent from the image engine on the host to the client. |
Image Quality |
Shows the current lossless state of the attached display:
|