Zero Client to Remote Workstation Card via View Connection Server (LAN)

The figure below shows a zero client establishing a PCoIP session with a remote workstation card from within a LAN using a View Connection Server to connect the endpoints.

Note: All remote workstation card scenarios assume you have the PCoIP host software installed on the host PC or workstation. For details, please see “PCoIP® Host Software for Windows User Guide” (TER1008001) in the Teradici Support Documentation Center. This scenario also assumes you have the VMware View Agent software installed on the host PC or workstation. For more information, see “Using PCoIP® Host Cards with VMware View” (TER0911004) in the Teradici Support Documentation Center. Please refer to Connection Prerequisites for other conditions that may apply.

Zero Client to Remote Workstation Card via View Connection Server (LAN)

To establish the connection:

Note: For more information about configuring View Connection Servers, please refer to VMware documentation.

1. From the View Connection Server:
   • Install View Agent on the host workstation.
   • Create a manual pool that is configured to support PCoIP hardware, and then add the workstation to the pool.
   • Ensure that the Use Secure Tunnel connection to desktop check box is enabled. (This check box is enabled by default.)
   • Enter the View Connection Server's IP address or domain name for the External URL (e.g. 192.168.1.140:443 or https://myserver.com:443).
2. From the zero client's AWI:
   • Configure the View Connection Server session connection type, and enter the DNS name or IP address of the View Connection Server.
3. Start a PCoIP session.