Zero Client to Remote Workstation Card (LAN)

The figure below shows a PCoIP session between a zero client and remote workstation card from within a LAN.

Note: All remote workstation card scenarios assume you have the PCoIP host software installed on the host PC or workstation. For details, please see “PCoIP® Host Software for Windows User Guide” (TER1008001) in the Teradici Support Documentation Center. Please refer to Connection Prerequisites for other conditions that may apply.

Zero Client to Remote Workstation Card (LAN)

To establish the connection:

1. From the zero client's AWI:
   • Configure the Direct to Host session connection type, and enter the DNS name or IP address of the remote workstation card.

2. From the remote workstation card's AWI:
   • Configure the Direct from Client session connection type, and whether to accept any peer (i.e., zero client) or a specific one.
3. Start a PCoIP session.
4. If necessary, adjust bandwidth and image parameters on both the host and client to optimize performance.